Earth Support Corp

Rockingham CountyNew Hampshire

Salem, New Hampshire

Bedrock sits a median 15 ft down across 1,139 logs, shallower than the New Hampshire median of 20 ft. 1 high-hazard dam is rated in poor or unsatisfactory condition.

Median depth to bedrock

15 ft

middle half 8–35 ft · 1,139 logs

Bridges rated poor

1

of 24 inventoried

Poor high-hazard dams

1

National Inventory of Dams

FEMA repair $, Rockingham County

$22.0M

federal share since 2010 · county-wide

01 · Ground

Rock is close to the surface: 41% of logs hit it within 10 ft

From 1,139 depth-to-rock records inside Salem (NH DES well inventory). Logs cluster where people drill wells and bore for roads, so treat this as the town’s pattern, not a site answer.

Half of Salem's logs reach rock between 8 and 35 ft

Depth to bedrock: 10th–90th percentile whisker, middle-half box, median tick; dashed line = New Hampshire median.
median 15 ft
NH 20 ft
0204060 ft
0501001502002503000–5 ft5–10 ft10–20 ft20–50 ft50–100 ft100+ ft
n = 1,139 logsSource: NH DES well inventory
▸ Show the numbers
Depth to rock (ft)Logs
0–5124
5–10259
10–20287
20–50284
50–100147
100+38

Rock within 10 ft

41%

of logs (31% across New Hampshire). Shallow rock means ledge in excavations, refusal for driven piles and rock anchors rather than soil nails; deep ground means taller shoring and more groundwater. 15% of logs here go past 50 ft.

02 · Dams & disasters

1 high-hazard dam needs work

FEMA Public Assistance is reported by county, so the figure below is Rockingham County-wide context, not a Salem number.
High-hazard dams in poor condition in Salem
DamConditionBuilt
Millville Lake DamHitty Titty BrookPoor1917

High hazard potential means failure would probably cost lives — it rates the consequences, not the dam’s condition.

FEMA Public Assistance, Rockingham County

$22.0M

Federal share obligated across 662 projects in 14 declared disasters since 2010. The largest category is emergency protective measures (79%); roads & bridges took $2.0M.
Dams, disasters & moving ground

03 · Bridges

1 of 24 bridges are rated poor — below the New Hampshire rate of 8%

Every highway bridge and large culvert in the 2025 National Bridge Inventory that stands inside Salem. Median age 18 years.

79% good, 4% poor

FHWA good / fair / poor rating — the lowest of deck, superstructure, substructure or culvert.
  • Good19 · 79%
  • Fair4 · 17%
  • Poor1 · 4%

Structures by decade built

0246810pre-19101950s1960s1990s2000s2010s2020s
n = 24 structuresSource: FHWA National Bridge Inventory 2025
▸ Show the numbers
BuiltStructures
pre-19102
1950s1
1960s5
1990s1
2000s5
2010s9
2020s1

The poor-rated bridges

Bridges rated poor in Salem
CarriesOverBuiltDaily traffic
BRIDGE STREETSPICKET RIVER19004,883
Every poor bridge in New England

04 · Next door

Salem and the 6 towns that border it

A dash means no data for that layer, not zero.
Salem compared with neighbouring towns
TownPoor bridgesRock depth
Salem, NH1 / 2415 ft
Haverhill, MA11 / 3750 ft
Methuen, MA5 / 3123 ft
Derry, NH0 / 1612 ft
Windham, NH0 / 138 ft
Pelham, NH1 / 615 ft
Atkinson, NH18 ft

Where these numbers come from

Method, sources & caveats

Salem is the Census county subdivision 3301566660 (Rockingham County). Every record is placed here by its coordinates, not by the place name the source uses.

  • Towns are Census county subdivisions: cities, towns, plantations, and Maine/New Hampshire unorganized territories and townships. Every record is placed in a town by its coordinates (point-in-polygon), not by the source's own place label — so a bridge in Roxbury counts for Boston and a well in 'North Waltham' counts for Waltham.
  • Bridges: FHWA NBI 2025, highway structures ≥ 20 ft including large culverts. 'Poor' is FHWA's good/fair/poor rating (lowest of deck, superstructure, substructure or culvert ≤ 4). Percent-poor is shown only for towns with at least 5 structures.
  • Depth to bedrock is the median of driller- and boring-reported depths in the town, shown only where at least 10 logs exist. Water-well logs over-sample rural lots and hilltops; one town median never describes a particular site.
  • Bedrock depths use the same state databases and filters as the Bedrock & soils module (bedrock wells and borings that reached rock, 0 < depth ≤ 400 ft, exact re-filings dropped), but every log is placed in a town by its coordinates rather than the driller's town field, so town counts can differ slightly between the two pages. Connecticut and Rhode Island have no statewide public well-log database with depths.
  • Dams: only high-hazard-potential dams whose latest condition assessment is Poor or Unsatisfactory are counted (live NID). Connecticut and Rhode Island assessments may lag.
  • FEMA Public Assistance dollars are federal share obligated for disasters declared since 2010, reported by county — they are county context, not a town figure.
  • Grant awards are Massachusetts only (EEA Dam & Seawall program, MVP Action grants, CZM Coastal Resilience). Other states' programs are not yet included.
  • Ground-related permit counts cover only the municipal portals the pipeline reads (Boston, Cambridge, Somerville, Worcester, Framingham, Providence, Portsmouth, Hartford and a few others) — an absent count means 'not covered', not zero.
Data as of
Sep 11, 2026
Generated
Sep 11, 2026
Records
367,748
Refresh
Live pull · weekly

Published by Earth Support Corp as a public resource. Regional statistics for planning and curiosity. They are not an engineering report, a bid recommendation or a statement about any particular site, firm or project. Spot an error? Tell us and we will correct it. Full method: methodology.

CallStart Quote